Honeywell HX3, User Manual, Page: 113 / 230

7 - 3
Enable Internal Scanner Sound
Default: Enabled. Functionality of the internal scanner driver engine includes audible tones on good scan (at the maximum
db supported by the speaker) and failed scan. Disable this parameter when good scan/bad scan sounds are to be handled
by alternate means e.g., application-controlled sound files. Rejected bar codes generate a bad scan beep. In some cases,
the receipt of data from the scanner triggers a good scan beep from an external scanner, and then the rejection of scanned
bar code data by the processing causes a bad scan beep from the HX3 on the same data.
Single Scan
Single Scan determines if scanner input is inhibited after a scan until the scanner is re-enabled. Off - Single Scan mode is
off. Auto - Single Scan mode is on. The scanner is disabled after a scan and automatically re-enabled by the scanner
driver after retrieving the bar code data. Man - Single Scan mode is on. The scanner is disabled after a scan and the user
application must call LXEScannerSSReset to re-enable the scanner. See the
CE API Programming Guide for more details.
This option is only supported on Symbol (Motorola) internal and BTRS scanners. The scanner may require a firmware
upgrade to support this feature.
Imager LED Illumination
The default setting is Internal illumination. The imager has a bank of three LEDs above the imager aperture that illuminate
when External or Both radio buttons are enabled. The illumination turns off when the scan is complete.
COM1 Tab
This panel sets communication parameters for any device connected to the external port.
Adjust the settings and click the OK button to save the changes. Any changes take effect immediately.
This panel does not configure the connected device. Refer to the documentation for the external connected or wireless device
for information on configuring the device.
Note: COM default values are restored after a cold boot or operating system upgrade.