Honeywell HX2, Reference Manual

Page: 257 / 310

LEAP
To use LEAP (without WPA), make sure the following profile options are used.
l
Enter the SSID of the Access Point assigned to this profile
l
Set EAP Type to LEAP
l
Set Encryption to WEP EAP or Auto WEP (depending on SCU version)
l
Set Auth Type as follows:
l
If the Cisco/CCX certified AP is configured for open authentication, set the Auth Type radio parameter to
Open .
l
If the AP is configured to use shared key or passphrase, set the Auth Type radio parameter to Shared .
l
If the AP is configured for network EAP only, set the Auth Type radio parameter to LEAP .
See Sign-On vs. Stored Credentials for information on entering credentials.
6-27