Honeywell HRSD40F, User Manual

Page: 89 / 168

Document 800-03097 Rev C 89
03/09
Configuration
Note For the Notify action, the notify item you select should be
enabled in the Notification setup screen and the DVR should be
registered in the RAS (Remote Administration System).
6. Highlight a field under the PTZ heading, and press . A list of PTZ presets
appears. Select the preset position for each PTZ camera, where you want PTZ
cameras to move to whenever the DVR detects motion on the selected camera’s
input.
7. Save your Motion Detection changes by highlighting Save and pressing .
Select Cancel to exit the screen without saving the changes.
Configuring for Video Loss
You can configure the DVR to detect and react to video loss. The DVR checks to see if
anything is obscuring the camera. Then, the DVR can be set to react to video loss
differently for each camera. Each camera can:
•
Be associated with another camera
• Trigger an Alarm-Out connector
• Sound the DVR's internal buzzer
• Notify a number of different devices
• And/or move PTZ cameras to preset positions
Set the Sensitivity for Checking Camera Obscuration
1. Highlight Video Loss in the Event menu and press . The Video Loss setup
screen appears.