Honeywell HRSD40F, User Manual

Page: 34 / 168

34
HRSD40F DVR User Guide
Note A separate ALARM button is not provided. Press any key on the
front panel or remote control resets alarm output, including the
internal buzzer, when the alarm is activated. However, when you
are in the menu or PTZ mode, you have to exit the menu or PTZ
mode first to reset alarm output.
Note The sensor for the infrared remote control is to the left of the
MENU button on the front of the VCR. Ensure that nothing
blocks the sensor, or the remote control will not function
properly.
Table 3-1 DVR Front Panel Controls
# Control Function
1 Camera Buttons
(1 to 4) Press an individual camera button to display a selected camera full
screen. Press the button again to change the display format to the
quad (2x2) mode.
Use the camera buttons to enter passwords (which contain only
numbers).
Use the camera buttons in the PTZ mode in the following ways:
•
Camera 1 zooms in
• Camera 2 zooms out
• Camera 3 controls near focus
• Camera 4 controls far focus
2 POWER LED The POWER LED lights when the unit is On .
3 ALARM LED The ALARM LED lights when alarm output or internal buzzer is
activated.
4 HDD LED The HDD LED lights when the DVR is recording. When the DVR is in
the panic recording mode, the HDD LED flickers.