Honeywell HRSD16, User Manual

Page: 54 / 176

Configuration
54
3. Change the numbers by highlighting them and using the UP and DOWN arrows
to increase or decrease the number.
The factory default LAN settings are:
IP Address:
192.168.1.129
Gateway:
192.168.1.254
Subnet Mask:
255.255.255.0
4. Highlight the field beside DNS Server. Press the UP and DOWN arrows to set the
IP address of the DNS server.
5. Highlight the Port Number Setup… field and press . The Port Number Setup
screen appears.
Figure 3-25 Port Numbers Setup Screen
6. Change the numbers by highlighting them and pressing to select the number
field. Use the UP and DOWN arrows to increase or decrease the number value.
The factory default Port settings are:
Remote Admin:
8200
Remote Callback:
8201
Remote Watch:
8016
Remote Search:
10019
Note You need to get the appropriate Port Numbers for each
RASplus and webGuard related program (Admin,
Callback, Watch, and Search) from your network
administrator.
The system restarts automatically after changing the port settings.
Do NOT use the same port number for two different
programs. If you do, the DVR cannot be connected with
the PC running RASplus or WebGuard.
Caution When changing the port settings, you must change the port
settings on the PC running RASplus or WebGuard. Refer to the
RASplus manual for details.