www.honeywell.com/security
182 | Embedded Network Video Recorder User Guide
PTZ Activation
When PTZ activation is configured, the system can activate
PTZ operation when an alarm is detected.
1. Click
Set
to open the
PTZ Activation
configuration
interface.
2. Select a preset, tour, or pattern from the drop-down menu.
3. Click
Save
.
Tour
Click to enable a tour to be triggered by an alarm. The system
supports 1/8-window tour. See
for tour interval setup. On the
Display Settings
tab, when there are two tours enabled by default, you can
configure the system so an alarm triggers the system to
enable the alarm tours you configured here. If there is no
alarm, then the system uses the tour setup that was
configured in the
Display
interface.
1. Click
Setup
to select a tour channel. The system begins a
1-window or multiple-window tour display showing the
channels you’ve set to record when an alarm occurs.
2. Click to select a channel, or
All
, then click
Save
.
Snapshot
Click to enable the
Snapshot
function. A snapshot will be
taken when an alarm occurs.
1. Click
Set
to open the Snapshot Configuration interface.
2. Click to select a channel, or
All
, then click
Save
.
Table 5-19
Motion Detection Configurations
Configuration
Description
Summary of Contents for HEN04111
