Honeywell HEN04111, User Manual

Page: 122 / 248

www.honeywell.com/security
122 | Embedded Network Video Recorder User Guide
Figure 3-67 Abnormality Configuration Interface
Table 3-31 Abnormality Configurations
Configuration Description
Event Type Select from No Disk , Disk Error , Disk No Space , Net
Disconnection , IP Conflict , or MAC Conflict .
Enable Click to enable the Abnormality function.
Alarm Out Select an alarm activation output port.
Latch When an event is complete, the system automatically delays,
for a specified time, the NVR from detecting new events.
Show Message Click to enable a popup message to alert you when an alarm
occurs.
Alarm Upload Click to enable the system to upload the alarm signal to the
network (including an alarm center and the web client). The
system uploads only the alarm channel status.
Go to the Web operation, and then go to the Alarm interface
to set the alarm event and alarm operation. See Enabling and
Disabling Alarms on page 157 and Configuring Alarms on
page 184 .
Send Email The system can send an email when an alarm is detected.
When you have enabled the
Snapshot function, the system
can also send an image attached to the email. Go to Main
Menu

Setting

Network

Email to configure the email
settings. See Configuring the Email Settings on page 84 .
Buzzer Click to enable the Buzzer function. When an alarm occurs,
the buzzer beeps.