40X ZOOM IR PTZ DOME CAMERA USER GUIDE
75
between 0 and 100 seconds. The system will only allow one alarm event
within this period.
6.
Set
Sensor Type
to
NO
(normally open) or
NC
(normally closed),
depending on the alarm input type.
7.
To start recording video when an alarm event is detected, select the
Record
check
box.
8.
In the
Record Delay
field, enter the number of seconds that the system will
continue to record video after an alarm event has ended. Enter a value
between
10
and
300
.
9.
To generate an alarm output when an alarm event is detected, select the
Alarm
Output
check box and select the alarm output(s) to be activated.
10.
In the
Alarm Delay
field, enter the number of seconds that the system will
continue to generate an alarm output after an alarm event has ended. Enter a
value between
10
and
300
.
11.
To send an email notification when an alarm event is detected, select the
Send Email check box. Email settings must be configured in
Setting
Network
SMTP (Email)
.
12.
To initiate a predefined preset, tour, or pattern when an alarm event is
detected, select the PTZ check box and select the desired action from the
Activation list.
13.
To take a snapshot when an alarm event is detected, select the
Snapshot
check box.
Note
For the snapshot to be attached to the email notification, the
Attachment
check box must be selected in
Setting
Network
SMTP(Email)
.
14.
Click
Save
to apply the settings.
Configuring Abnormality
You can configure system event settings (for SD card and network errors and
illegal login attempts).
Configuring SD Card
There are three types of SD card events:
•
No SD Card: There is no microSD card installed in the camera.
•
SD Card Error: The installed microSD card is not working.
•
Capacity Warning: The installed microSD card is full. You can configure settings for
each type of event.