Honeywell HDZ20HD, User Manual, Page: 86 / 164

www.honeywell.com/security
86 | HDZ Series IP PTZ User Manual
should be set to PAL by default. If this unit was purchased in an NTSC region, the camera should
be set to NTSC by default. Check with the system administrator if you are unsure what setting
to use at your location.
Note This feature is only supported by the HDZ PTZ models: HDZ20HD(X),
HDZ20HDE(X), HDZ30HD, and HDZ30HDE.
Switching the TV System Setting
1. Navigate to PTZ

Camera .
2. Under Misc (see Figure 5-14 ), in the TV System drop-down list, select one of the
following:
• 30 fps(NTSC) 1080p to use the North American TV system setting. This is the default
setting if the camera is the NTSC model.
• 25 fps(PAL) 1080p to use the European TV system setting. This is the default setting
if the camera is the PAL model.
• 60 fps(NTSC) 720p to use the North American TV system setting.
• 50 fps(PAL) 720p to use the European TV system setting.
3. Click Set to save the setting.
Restore Defaults
You can undo any changes that you have made to the camera settings and restore the camera
to its factory default settings. See also
Restoring Factory Defaults on page 134 .
Restoring the Camera Default Settings
1. Navigate to PTZ

Camera .
2. Under Default , click Set default (see Figure 5-14 ).