Honeywell HD54IP, User Manual

Page: 63 / 84

Performance Series Rugged Day/Night H.264 IP Dome Camera User Guide
Document 800-09311V3 Rev A 63
07/2013
Configuring Camera Field of View Change Detection
The web client application can detect tampering of the camera field of view and show an
alarm message above the video display (see
Figure 4-14 ). To detect a change in the
camera field of view:
1. Click the Video Analytics tab.
2. In the Scene Change Threshold list, select one of the following options:
3. Click Apply .
Note To turn off camera field of view change detection, select Disable in the Scene
Change Threshold list. Disable is the default value.
Note You must click Apply after you make changes to any settings to save those
changes. Settings are not saved unless you click Apply .
Configuring Video Motion Detection
For motion detection, an Administrator can enable and configure up to five zones within a
scene. The enabled and configured zones will be monitored for motion.
1. Click the Region drop-down menu, then select a region from the five available.
2. Click the VMD drop-down arrow, and select Enable .
The Regions appear in their default positions.
3. Click Apply .
4. Click and drag the box to resize and place it over the camera image.
5. Select the sensitivity level (High, Medium, Low).
Table 4-10 Scene Change Threshold Values
Value To detect …
High (80%) Maximum change in the camera field of view. The alarm
message appears when tampering causes at least an 80%
change in your camera field of view.
Medium (50%) Medium change in the camera field of view. The alarm
message appears when tampering causes at least a 50%
change in your camera field of view.
Low (30%) Minimum change in the camera field of view. The alarm
message appears when tampering causes at least a 30%
change in your camera field of view.