Honeywell HD54IP, User Manual

Page: 24 / 84

24
Installation and Setup
Note Check the power source from the external power supply before applying
power to the camera.
Connect to Power Input
Caution When powering the camera from 24 V AC, a UPS source should be
used to ensure satisfactory performance.
Connect the power supply that is appropriate for your installation:
• 24 V AC power supply
• Power over Ethernet (IEEE 802.3 af) 48 V DC power supply
Note Connect power either from a 24 V AC source or a CAT5 Ethernet connector
(PoE). It is recommended that you do not connect both power sources at the
same time.
Note If you are using PoE (802.3af), power will automatically be supplied to the
camera through the network cable.
1. Connect to the power supply (see Figure 2-5 on page 25 ). Locate the two-pin green
connector that was shipped with your camera and make the necessary connections.
2. Plug the power supply into an appropriate power source. The LED on the RJ45 jack
illuminates to show that the camera is receiving power. If it does not illuminate, check
the terminal block connections and the power source.