Honeywell HD54IP, User Manual

Page: 23 / 84

Performance Series Rugged Day/Night H.264 IP Dome Camera User Guide
Document 800-09311V3 Rev A 23
07/2013
Installing the Camera
Step 6. Mounting the Camera
1. Pull the wires through the back conduit entry if that is the entry you are using.
2. Align the mounting holes in the base with the holes you have predrilled in the
mounting surface, then secure the camera to a wall or ceiling using the supplied
screws (see
Step 3. Preparing the Mounting Surface on page 21 ).
If you are using screws other than those supplied by Honeywell, then please remove
the rubber washers from the Honeywell-supplied screws, and then install them under
the head of each of your screws. See
Figure 2-4 on page 22 .
Note To prevent moisture from entering the housing, ensure that the gasket is flush
against the back of the camera enclosure and is not pinched.
Step 7. Connecting the Wiring
Caution When connecting to a power supply, use either a 24 V AC power plug
or use a PoE IEEE 802.3af (Power over Ethernet) compatible hub.
Caution Installation must be performed by a qualified electrician. The power
wire size for the distance and the number of cameras must be
determined to maintain 24 V AC at each camera.
Caution The use of a CSA Certified/UL Listed Class 2 power supply is required
to ensure compliance with electrical safety standards.