Document 800-19473 – Rev A – 12/2014
Performance Series HQA HD30HD1(X)
720p Indoor/Outdoor IR Ball Camera
1
Quick Installation Guide
Document 800-19473 – Rev A – 12/2014
Thank you for purchasing a Honeywell Performance Series HQA HD30HD1(X) camera. Follow the
instructions in this guide to install and set up your camera.
Cautions and Warnings
Important Safeguards
•
Read and keep these instructions.
•
Do not aim the camera toward a bright light source for extended periods to prevent damage to the
imager. Avoid operating the unit under or close to unstable light sources or close to fluorescent
lamps or objects reflecting light.
•
Do not touch the camera lens.
•
Do not drop the camera or subject it to physical shock.
•
Do not use a strong or abrasive detergent when cleaning the camera.
•
Avoid operating or storing the unit in extremely humid, dusty, or environments where the operating
temperature is outside the recommended range of –22°F to 140°F (–30°C to 60°C).
Dimensions
Before You Begin
Before you begin, check that you have received all of the parts listed below. If any parts are missing or
damaged, contact your dealer immediately.
Tools needed (not supplied):
•
Cordless drill
•
Phillips screwdriver
Preparing the Mounting Surface
1.
Inspect the site where you want to install the camera. The mounting surface must be flat and capable
of supporting at least three times the weight of the camera.
2.
Remove the backing from the mounting template sticker and affix the sticker to the mounting surface.
3.
Drill the screw holes and cable exit hole at the locations indicated on the mounting template sticker.
4.
Insert the four supplied plastic anchors in the holes.
5.
Pull the power and video cables through the hole.
Mounting the Camera
1.
Remove the mounting base from the camera.
a.
Loosen the two set screws on the base ring.
b.
Unscrew the base ring from the mounting
base.
2.
Attach the mounting base to the mounting surface
using the supplied screws.
3.
Connect the power and video cables.
a.
Connect the power connector of the camera
to a 12 V DC power source.
b.
Connect the BNC connector of the camera
to a coaxial video cable.
WARNING
This device is configured for 12 V DC operation. Do not connect to a higher
voltage. Use only with NRTL-approved Class 2 power supplies.
WARNING
IR emitted from this product. Do not view directly with optical instruments.
Do not stare directly into the lamp at a distance of less than 3.3 ft (1 m).
CAUTION
Class 1 LED product. Invisible LED radiation (850 nm). Avoid exposure to beam.
•
Camera
•
Self-tapping screws (4)
•
Quick Installation Guide
•
Plastic anchors (4)
•
Mounting template sticker
•
Power pigtail
•
Allen key (L-wrench)
1
Mounting Base
Base ring
Middle ring
Camera body
2
