Honeywell HCD5HIH, Reference Manual

Page: 74 / 104

74
IP Camera Web Client
2. In the Scene Change Threshold list, select one of the following options:
3. Click Apply .
Note To turn off camera field of view change detection, select Disable in the Scene
Change Threshold list. Disable is the default value.
Note You must click Apply after you make changes to any settings to save those
changes. Settings are not saved unless you click Apply .
Configuring Video Motion Detection
For motion detection, an Administrator can enable and configure up to 5 zones within a
scene. The enabled and configured zones will be monitored for motion.
1. Click the Video Analytics tab in the web client user interface.
2. Click the Region drop-down menu in the Video Motion Detection pane, then select a
region from the five available.
3. Click the VMD drop-down arrow, and select Enable .
The Regions appear in their default positions.
4. Click and drag the box to resize and place it over the camera image.
This box is the region of interest.
5. Select the sensitivity level: 30% (most sensitive), 50% (medium sensitivity), or 80%
(least sensitive).
We recommend that you use the medium sensitivity at 50% as the initial setting. It can
be further adjusted as explained in
Fine Tuning Video Motion Detection on page 75 .
6. Click Apply .
Table 4-14 Scene Change Threshold Values
Value To detect …
High (80%) Maximum change in the camera field of view. The alarm
message appears when there is at least an 80% change in
your camera field of view.
Medium (50%) Medium change in the camera field of view. The alarm
message appears when there is at least a 50% change in
your camera field of view.
Low (30%) Minimum change in the camera field of view. The alarm
message appears when there is at least a 30% change in
your camera field of view.