Honeywell Granit 1911i, User Manual

Page: 100 / 266

4 - 10
In-Stand Sensor Mode
Note: The In-Stand Sensor feature only applies to Xenon products.
This feature senses when the scanner is removed from the stand and tells it to begin manual triggering. When Sensor On is
enabled, the scanner defaults to Streaming Presentation Mode when it is in the stand, and to Manual Trigger Mode when it is
removed from the stand. Default = Sensor On.
Note: If you are taking images (see Imaging Commands beginning on page 8-1), you must set the In-Stand Sensor to Off .
You may program a Streaming Presentation Mode (Normal, Enhanced, or Mobile Phone) you wish to use for in-stand scanning,
and a Manual Trigger mode (Normal, Enhanced, or Mobile Phone) you wish to use for out-of-stand scanning. To do this, you
must first scan the preferred Streaming Presentation mode (see below), then scan the Manual Trigger mode (see
page 4-6 and
page 4-11 ) you want to use.
CodeGate
®
When CodeGate is On , the trigger is used to allow decoded data to be transmitted to the host system. The scanner remains on,
scanning and decoding bar codes, but the bar code data is not transmitted until the trigger is pressed. When CodeGate is Off ,
bar code data is transmitted when it is decoded. Default = CodeGate Off Out-of-Stand.
Left of
Presentation Centering
Window
Right of Presentation Centering
Window
* Sensor On
Sensor Off
* CodeGate Off
Out-of-Stand
CodeGate On
Out-of-Stand