EQUIP
®
Series ACUIX™ IP PTZ Dome Installation and Configuration Guide
Document 800-04194V1 Rev A
45
07/11
Setting Pan Reverse
You can reverse the pan so that a left pan command from the controller will
cause the camera to pan right and a right pan command will cause the camera
to pan left.
To enable/disable pan reverse:
1.
From the OSD main menu, press
3
to select
Control Options
.
2.
Press
4
to select
Set Pan and Tilt Options
.
3.
Press
2
to set pan reverse to
ON
or
OFF
(default).
Setting Tilt Reverse
You can reverse the tilt so that a tilt up command from the controller will cause
the camera to tilt down and a tilt down command will cause the camera to tilt up.
To enable/disable tilt reverse:
1.
From the OSD main menu, press
3
to select
Control Options
.
2.
Press
4
to select
Set Pan and Tilt Options
.
3.
Press
3
to set tilt reverse to
ON
or
OFF
(default).
Setting the Tilt Limit
You can allow the camera to tilt five degrees above the horizontal using the
−
5
degree tilt limit feature.
To enable/disable
−
5 degree tilt limit:
1.
From the OSD main menu, press
3
to select
Control Options
.
2.
Press
4
to select
Set Pan and Tilt Options
.
3.
Press
4
to set the tilt limit to
ON
or
OFF
(default).
Summary of Contents for EQUIP Series
