Honeywell EQUIP HD4HDIH, User Manual

Page: 67 / 90

HD4 EQUIP Series True Day/Night Rugged IP Network Camera User Guide
Document 800-07496V2 Rev A 67
11/2011
Alarm Settings
Connect external devices such as sirens or flashing lights to the alarm output connector to
signal camera users that an alarm is activated. Set the
Alarm Output as Normally Open or
Normally Close . See Connecting Alarms on page 26 for more information.
When alarm inputs are connected, the camera triggers an alarm only when the normal state
(open or closed) changes. An alarm message appears on the web client screen (see
Figure 4-17 ) to notify the operator.
Audio Settings
The network camera supports bi-directional audio. There are two supported voice band
channels that function in full duplex mode. Connect industry-standard line level audio input
and output to the back of your camera. See
Connecting Audio on page 26 for more
information.
Audio configuration for your network camera is straightforward.
Figure 4-20 Audio Settings
To listen to or capture audio from the camera, enable the Camera to Client (PC) check box
( ). To listen to audio from the client (PC), enable the Client (PC) to
Camera check box.