Honeywell EQUIP HD4HDIH, User Manual

Page: 55 / 90

HD4 EQUIP Series True Day/Night Rugged IP Network Camera User Guide
Document 800-07496V2 Rev A 55
11/2011
Primary Stream Video Codec Settings
Figure 4-9 Video Codec Settings Tab Available Functions
Secondary Stream Video Codec Settings
Click on the Secondary Stream tab. A warning message appears:
The secondary
stream is disabled. To enable, select compression settings tab and
configure secondary stream.
(HD4HDIH only)
Figure 4-10 Video Codec Settings Tab Available Functions
Note Enabling the secondary (MJPEG) stream disables the local video out (aim
and focus). (HD4HDIH only)
Set the Resolution
Set the Frame Rate
Set the Priority to Quality, or Bit or Frame Rate
Set the Compression Ratio
Set the Target Bit Rate
Set the Maximum Bit Rate (kbps)
Set the GOP (Group of Pictures)
Default settings shown for NTSC models
Default settings shown for NTSC models
Enable / Disable the secondary stream
Set the Resolution
Set the Frame Rate
Set the Priority to Quality, or Bit or Frame Rate
Set the Compression Ratio
Set the Target Bit Rate (kbps)
Set the Maximum Bit Rate (kbps)