Document 800-00250 Rev C
21
08/08
3
Configuring Network Settings
The Honeywell IP Utility is used to provide the network connectivity for the network
camera system. The IP Utility automatically discovers Honeywell IP devices on the
network and enables you to configure the device settings. Using the IP Utility, you can
configure the IP network settings, name the camera(s), upgrade the firmware, and
change the user passwords of the device.
Preparing the Honeywell IP Utility
To perform the tasks required to discover the network cameras and configure their
settings, you must first install the IP Utility. After installing and logging on you can set the
passwords for users in order to control access to the IP Utility.
Note
Before installing and using the Honeywell IP Utility, make sure that your
camera is connected to your network through an Ethernet cable (see
).
System Requirements
The Honeywell IP Utility should be installed on a work station that meets the following
minimum requirements:
Table 3-1
PC Minimum System Requirements
Component
Requirement
Operating System
Windows
®
2000/XP®
Processor
Intel
®
Pentium
®
IV, 3.0 GHz or faster
RAM
512 MB or higher
Web Browser
Microsoft® Internet Explorer®, V6.0 or later
