10 - 1
Model 1010 Application Pack CB
Part No.: 4418024 - Rev. 1
Programming Manual
CHAPTER 10 AUTHORISATION ENTRY MODE
10.1 Description
To limit the entry to, or the use of, a loading gantry to authorised
personnel and vehicles, the instrument provides the following
identification methods:
Touch keys
RF ID proximity cards
PINs of four to eight digits
NexWatch cards.
If no restrictions are required, select ‘NONE’ for the personnel and
vehicle authorisations options within the GENERAL SETUP sub-menu
of the SYSTEMS menu.
If authorisation is to be used for personnel and/or vehicles, the desired
authorisation type must be configured under the GENERAL SETUP
sub-menu of the SYSTEMS menu before the PIN or Touch Key
numbers can be programmed.
The ID numbers for personnel and vehicle authorisation may be
downloaded to the instrument from an external computer, or entered
using the instrument keyboard.
Each ID number is associated with an index number, which is used to
identify the personnel or vehicle without revealing the PIN.
10.2 Entering Authorisation Entry Mode
1.
Do one of the following:
•
Hold the '8' key down for five seconds.
After using this method, you cannot alter certain parameters for
W&M.
•
Use the switch on the instrument.
