4 - 1
Model 1010 Application Pack CB
Part No.: 4418024 - Rev. 1
Programming Manual
CHAPTER 4 SYSTEM (2)
Use the System menu to change overall system operating parameters,
such as Language Options, Loading Prompts and Passwords.
The System sub-menus are as follows:
1 - General Setup
Use to select items like language options, system time-outs, personnel,
master and vehicle authorisations. See section 4.2.
2 - Loading Options
Use to set operating prompts and system options. See section 4.3.
3 - General Purpose Inputs
Use to select system permissives against a range of inputs. See section
4.4
4 - General Purpose Outputs
Use to select digital output functions to the general purpose outputs.
See section 4.5.
5 - Configure Deadman
Use to enable the Deadman system and set the applicable Deadman
time-outs. See section 4.6.
6 - Communications
Use to set the system communications parameters. See section 4.7.
7 - Configure Messages
Use to set operator prompts and system messages. Refer Section 4.8.
8 - Opto Outputs
The Opto Outputs sub-menu of the System menu allows the operator to
configure the various opto outputs. refer Section 4.9.
SYSTEM 2
7 - CONFIGURE MESSAGES
8 - OPTO OUTPUTS
1 - DISPLAY CONTRAST
2 - LOADING OPTIONS
3 - GENERAL PURPOSE INPUTS
PRESS ENTER TO SELECT
1 - GENERAL SETUP
SYSTEM 2
7 - CONFIGURE MESSAGES
8 - OPTO OUTPUTS
1 - DISPLAY CONTRAST
2 - LOADING OPTIONS
3 - GENERAL PURPOSE INPUTS
PRESS ENTER TO SELECT
1 - GENERAL SETUP
