Honeywell Dolphin CT60, User Manual

Page: 19 / 124

Dolphin CT60/CT60 XP Mobile Computer User Guide 7
CT60 XP Models
Charge the Battery Before Use
Dolphin CT60 computers ship with the battery significantly discharged of power.
Fully charge the battery before using your computer for the first time.
You can charge the battery with a Dolphin CT50/CT60 charging accessory before
or after you install the battery in the computer. A fully discharged battery charge in
approximately
6 hours .
To charge the battery before you install it in the computer:
• Insert the battery into the Honeywell Quad Battery Charger or the battery well of
a CT50 HomeBase or eHomeBase.
To charge the battery after installing it in the computer:
• Insert the computer into a CT50 HomeBase, eHomeBase, ChargeBase, NetBase,
USB Adapter, or Vehicle Power Adapter.
Note:
Using the computer while charging the battery increases the time required to reach
a full charge.
Battery Replacement
If your battery power is low, you need to either charge the battery in the computer
or replace it with a charged battery.
Model Configuration
x = configuration variations
Battery P/N
CT60-xxx-xxPxx0x 318-055-018
CT60-xxx-xxPxx1x 318-055-019
CT60-xxx-xxPxxDx 318-055-020
Configuration number (CN) is located on the label in the battery well of the mobile
computer.
Caution: Read Battery Recommendations and Safety Precautions on
page 12 and all cautionary markings on the battery, charging
peripheral, and device using the battery before attempting to
install, use, or charge the battery.
Warning: If you have a CT60 model certified for use in hazardous
locations, read Important Information on page 5.