Honeywell CF3680, User Manual, Page: 141 / 203

CHAPTER
7
N3680 Decoded Engine User Guide 125
IMAGING COMMANDS
The scan engine is like a digital camera in the way it captures, manipulates, and
transfers images. The following commands allow you to alter the way the scan
engine performs these functions.
Note: If you are using the scan engine in a stand, you must set the In-Stand Sensor Mode
to Off in order to take images (see
Presentation Centering on page 38).
Single-Use Basis
Imaging Commands with their modifiers send instructions to the scan engine on a
single-use basis, and take effect for a single image capture. Once that capture is
complete, the scan engine reverts to its imaging default settings. If you want to
permanently change a setting, you must use the serial default commands (see
Chapter 9 ). When the serial default command is used, that selection becomes the
new, permanent setting for the scan engine.
Command Syntax
Multiple modifiers and commands can be issued within one sequence. If additional
modifiers are to be applied to the same command, just add the modifiers to that
command. For example, to add 2 modifiers to the Image Snap command, such as
setting the Imaging Style to 1P and the Wait for Trigger to 1T, you would enter
IMGSNP1P1T .
Note: After processing an image capture command (IMGSNP), you must follow it with an
IMGSHP command if you want to see it on your terminal.
To add a command to a sequence, each new command is separated with a semico-
lon. For example, to add the Image Ship command to the above sequence, you
would enter
IMGSNP1P1T ; IMGSHP .
The imaging commands are:
Image Snap - IMGSNP (page 126)