Installation
BRDG-
02M11
RF
Repeater
Honeywell
1
Check the contents
1.
Communication module.
2.
Power adapter
.
3.
Manual.
Connecting for
repeater functionality
LED Indication
Function
Action
LED
OFF
No message forwarded
LED
OFF
Repeater has learned at least 1 device
LED
ON
Repeater is in normal mode
R
estore the factory settings
:
Press the reset button for 10 seconds
, the power LED start blinking
, release the reset button
.
The repeater reboots
. All learned devices will be removed
.
1.
Co
nnect the communication module using the USB cable to the power adapter.
2.
Connect the p
ower
adapter to the 230V power outlet. LE
D , LED and LED are lit.
3.
Power LED starts blinking (repeater is now in learning mode for 5 minutes)
.
LED
blinking
shortly
Repeater forwarded a message
LED
ON
LED
blinking
Repeater hasn't learned a device yet
Repeater learned a new device,
blinks for 60s, after 60s the LED will be ON
To stop the blinking press the
reset butto
n for ~1s
,
the
LED will now be ON
. (see picture below
)
LED
blinking
Repeater
is in learning mode for 5 minutes
When the repeater is in normal mode you need to
power cycle the repeater to reenter learning mode
4. Bind the product that needs to be repeated
to each
other
. This binding procedure is just as normal
.
The
R
amses
repeater listens
for binding messages.
Once the Ramses repeater
recognizes that a
product sends a binding message,
this product is automatically
added to an
internal list of
repeated products. All messages from these products will be repeated from now on.
Notes:
A product is also added when it sends any message to a product that is already in the list. This is called “
Auto learning
”.
Wait 30 seconds before removing the power supply after a product is added to the list.
Changes in the list are saved periodically every 30 seconds.
