Honeywell A700, Hardware Reference Manual, Page: 140 / 334

NOTE
The high-noise headset has microphone cap storage located on the headband and above the
headset earcup.
A stability strap is available for this model.
Replacing an Earpad on the SRX2/SRX3 Hard-Hat or
High-Noise Headset
1. Remove the electronic module from the earcup.
2. Pry the earcup apart by grasping the inside and outside sections of the earcup and pulling
the two sections apart.
3. Remove the worn foam earpad from the inside plate.
Voice Device and Headset Hardware Reference Guide 118