Honeywell A700, Hardware Reference Manual, Page: 139 / 334

Replacing an Earpad on the SRX2/SRX3 Hard-Hat or
High-Noise Headset
1. Remove the electronic module from the earcup.
2. Pry the earcup apart by grasping the inside and outside sections of the earcup and pulling
the two sections apart.
3. Remove the worn foam earpad from the inside plate.
4. Gently pull a new foam earpad around the plate.
5. Align the inside posts of the two sections of the earcup.
6. Push sections together until they click into place.
SRX2/SRX3 High-Noise Headset
The SRX2/SRX3 High-Noise headset is a headset with a single ear cup that fits entirely over the
operator's ear to allow him or her to hear voice instructions clearly in areas of high
environmental noise. Combined with the optimal speech recognition of the headset using
SoundSense, this model offers an effective wireless solution for an industrial environment.
The single cup design gives operators the option of wearing the headset speaker on either ear for
their long-term comfort. It also provides protection in very cold environments, such as a
warehouse freezer.
117 Voice Device and Headset Hardware Reference Guide