Honeywell 60 Series, Configuration Manual

Page: 61 / 93

Configuring Video Analytics
47
5. Select
Enable motion detection
to enable this function.
Figure 6-1 Configuring Motion Detection Settings
Configuring Tampering Detection Settings
Go to Setup

Video Analytics

Tampering Detection .
This section explains how to configure camera tamper detection settings. With tamper
detection, the camera is capable of detecting incidents such as
redirection , blocking or
defocusing , or even spray paint .
Figure 6-2 Tampering Detection Configurations
Tampering detection : Check to enable tampering detection.
Image too dark detection : Check to enable image too dark detection. Too dark can be a cover
on the camera or a spraying paint on the camera.
Image too bright detection : Check to enable image too bright detection. Too bright can be a
flash light shining to the camera.
Image too blurry detection : Check to enable image too blurry detection. To blurry can be the
result of strong interference on the camera, such as EMI interference.
Trigger duration : It specifies a set of time before the tampering is considered as a real alarm.
This helps avoid false alarms by short-lived changes.
Trigger threshold : It determines how sensitive the tamper detection setting is. The lower the
threshold value, the easier the detection is triggered.