Honeywell 5010, User Manual

Page: 78 / 199

7 - 10
Code 39 Code Page
Code pages define the mapping of character codes to characters. If the data
received does not display with the proper characters, it may be because the bar
code being scanned was created using a code page that is different from the
one the host program is expecting. If this is the case, scan the bar code below,
select the code page with which the bar codes were created (see
Code Page
Mapping of Printed Bar Codes on page A-5), and scan the value and the Save
bar code from the Programming Chart on the inside the back cover of this
manual. The data characters should then appear properly.
Interleaved 2 of 5
< Default All Interleaved 2 of 5 Settings >
Interleaved 2 of 5
Check Digit
No Check Digit indicates that the imager reads and transmits bar code data with
or without a check digit.
When Check Digit is set to Validate, but Don’t Transmit , the unit only reads
Interleaved 2 of 5 bar codes printed with a check digit, but will not transmit the
check digit with the scanned data.
Code 39 Code Page
* On
Off