Configuring System Settings
131
The configuration for
ONVIF User
is very similar to the configuration for
User
, see
on page
for more information.
Configuring Security Settings
To allow specific sites to access the NVR
1.
Go to
Main Menu
SETTING
SYSTEM
Security
.
Figure 10-17 System Security Settings Window
2.
Select the
Enable
check box to enable IP filtering.
3.
Next to the
Enable
check box, click
Trusted Sites
.
4.
Click
Add
.
5.
To add a single IP address, select
IP Address
from the drop-down list and enter the IP
address of the site that you want to allow and click
OK
.
To add a range of IP addresses, select IP Section from the drop-down list and enter the
starting address in the upper IP address field and the ending address in the lower field,
and then click
OK
. Both IPv4 and IPv6 address are supported.
To add a specific machine, select
MAC Address
from drop-down list and enter the MAC
address of the machine you want to allow and click
OK
.
6.
Click
Apply
to save your settings.
7.
If you want to save your settings and exit the
SETTING
menu, click
OK
.
To block specific sites from accessing the NVR
1.
Go to
Main Menu
SETTING
SYSTEM
Security
.
2.
On the
IP Filter
page, select the
Enable
check box to enable IP filtering.
Summary of Contents for 2450Cm Series
Page 2: ......
Page 27: ...Getting Started 13 ...
Page 28: ...Performance Series Network Video Recorder User Guide 14 ...
Page 29: ...Getting Started 15 ...
