Lyric
TM
Controller
Supplement – Video Doorbell
Programming the Lyric Controller for Video Doorbells
Requirements
•
Full-time internet connection with at least 1.5mbps upload speed.
•
Router to which the Video Doorbell is connected must operate at 2.4GHz and support B/G mode.
•
Lyric Controller with firmware revision
01.03.06583.482
or later.
•
Total Connect 2.0 mobile app (if Video Door Bell not already connected to premise’s Wi-Fi router).
•
Video Doorbell Total Connect Service is enabled for the account (via AlarmNet 360).
Before you begin
•
If needed, download and install the Total Connect 2.0 mobile app to your smart device.
•
Perform the physical installation of the Video Doorbell according to its instructions.
Installation
If the Video Doorbell is not connected to the premise’s Wi-Fi network, perform step 1. Otherwise, skip to step 2.
1.
Connect the Video Doorbell to the premise’s Wi-Fi network
.
a. Put the doorbell into hotspot mode (press and hold the doorbell button until it blinks alternating red and green).
b. Start the Total Connect 2.0 mobile app and select the
Doorbell
(
Skybell
) menu.
Press
SETUP SKYBELL
, then press
NEXT
.
c. Select the video doorbell from the displayed list of devices to connect the device to the Video Doorbell hotspot.
Press
NEXT
.
d. Select the premise’s Wi-Fi router from the displayed list of devices to connect the Video Doorbell to the premise’s
Wi-Fi network. Press
NEXT
. Enter the router’s password if required, then press
NEXT
.
e. A popup message appears: “Your SkyBell front door has been added to Total Connect.” Press
OK
. The Video
Doorbell is now ready to be configured for use with the Lyric Controller.
NOTE
: The Wi-Fi sync process may require more than one attempt to connect. If needed, use the
Try Again
button
to reattempt.
2.
Configure the Video Doorbell for use with the Lyric Controller
.
a. Using the smart device browser (or PC with IE 10.0 or higher), go to
:https://hwinstall.myskybell.com/
b. Enter access code:
resideolyriccontroller
Enter Video Doorbell serial number: __________________________
(serial number located on the label on the back of the doorbell)
c. Select
Configure
.
Displays “Success! The SkyBell has successfully been updated with the Lyric Panel configuration.”
Exit the website. The doorbell is now ready to be added to the Lyric Controller.
(
continued on other side
)
