Honeywell Home Ademco Vista Series, User Manual

Page: 41 / 64

37
Testing the System
About Testing the System
Using the Test mode allows each protection point to be checked for proper operation. Testing should be
conducted weekly to ensure proper operation
.
• The keypad sounds a single beep about every 30 seconds as a reminder that the system is in the
Test mode.
•
Alarm messages are not sent to your Central Station while Test mode is on.
1. Disarm the system and close all protected windows,
doors, etc. The READY indicator light should come on if
all zones are intact (i.e., all protected windows, doors,
etc. are closed.
Alpha Displays:
∗∗∗∗
DISARMED
∗∗∗∗
READY TO ARM
2. + 5
TEST
then [0] (walk)
(Master Code)
The Dial test (option “1”) is intended for the installer and
should not be used unless directed to do so by your
Security System Representative.
1 = DIAL, 0 = WALK
3. Listen. The external sounder should sound for about 1
second then turn off. If the sounder does not sound, CALL
FOR SERVICE. The “Test in Progress” display appears
only on the keypad that started the test.
TEST IN
PROGRESS
4. Fault zones. Open each protected door and window in turn and listen for three beeps
from the keypad. Identification (zone number or zone description) of each faulted
protection point should appear on the display. The display clears when the door or
window is closed.
5. Walk in front of any interior motion detectors (if used) and listen for three beeps. The
identification of the detector should appear on the display when it is activated. The
display clears when no motion is detected.
Note that if wireless motion detectors are
used, there is a 3-minute delay between activations. This conserves battery life.
6. Test all smoke detectors, following the manufacturer's instructions. The identification of
each detector should appear on the display when each is activated.
If a problem is experienced with any protection point (no confirming sounds, no
display), call for service immediately.
When all protection points have been checked and are intact (closed), there should be
no zone identification numbers displayed on the keypad.
7. Exit test mode:
+
1
OFF
(Security Code)
If the test mode is inadvertently left active, it automatically turns off after 4 hours. During
the final five minutes, the keypad will emit a double beep every 30 seconds.