21
Date and Time
Viewing the Current Date and Time
The master users can view the system time and date setting on an alpha keypad. Other users can view
the date/time if a function key has been programmed to do so.
+ [#] + [6] [3]
(Master Code)
OR,
Press the function key (A, B, C, or D) for viewing current
date and time, if programmed.
Alpha Display:
∗∗∗∗
DISARMED
∗∗∗∗
READY TO ARM
A typical time/date display is shown.
The display will remain on for about 30 seconds or until a
key is pressed.
TIME/DATE
SAT
12:05AM_05/09/00
“A”
“B”
“C”
“D”
If one of the above keys has been programmed for the date/time display feature, place a check mark in
the box beneath that key.
Setting the Date and Time
NOTE: All partitions must be disarmed before date/time can be set.
You can set the time and date by doing the following:
1. +[#] + [6] [3]
(Master Code)
Alpha Display:
∗∗∗∗
DISARMED
∗∗∗∗
READY TO ARM
2. Press [
∗
] when the time/date is displayed.
A cursor appears under the first digit of the hour.
To move cursor ahead, press [
∗
]. To go back, press [#].
•
Enter the 2-digit hour setting.
•
Enter the 2-digit minute setting.
•
Press [1] for PM or [2] for AM.
•
Enter the last two digits of the current year.
•
Enter the 2-digit month setting.
•
Enter the 2-digit day setting.
3. To save and exit, press [
] when cursor is at the last
digit. If you wait and let it timeout, it will not save.
TIME/DATE
SAT
04:04PM 10/17/00
Current time display
TIME/DATE
SAT
04:04P2000/10/17
Time/date editing display
Summary of Contents for Ademco Vista Series
Page 62: ...58 NOTES...
