Honda WX15T, Manual

Page: 73 / 100

9-6
dummyhead dummyhead
PUMP
MECHANICAL SEAL REPLACEMENT
Drive out the mechanical seal [1] from the inside using
the special tools.
Drive the mechanical seal [1] until it is fully seated on
the end using the special tools.
• Be careful not to damage the sliding surface of the
mechanical seal.
After installing, check to be sure the seal is fully seated
and is not tilted in the casing cover.
Install a new rubber ring [1] over a new ceramic ring [2].
• Be careful not to damage the sliding surface of the
ceramic ring .
Apply soapy water around the rubber ring. Install the
rubber ring/ceramic ring assembly into the impeller [3]
carefully with the rubber ring facing the impeller until it
is fully seated.
TOOLS:
Driver handle [2]
07749-0010000
Bearing driver attachment,
28 x 30 mm [3] 07946-1870100
[1]
[2]
[3]
TOOL:
Driver handle [2]
07749-0010000
Oil seal driver attachment,
27.5 x 44 mm [3] 07948-9540000
[3]
[1]
[2]
[3]
[2]
[1]