Honda SH300I 2006, Manual

Page: 430 / 511

BATTERY/CHARGING SYSTEM
19-8
ALTERNATOR
INSPECTION
Remove the luggage box (page 3-5).
Disconnect the alternator 3P connector.
Measure the resistance between each Yellow wire
terminals.
Check for continuity between each wire terminal of
the alternator/stator side connector and ground.
There should be no continuity.
Replace the stator (page 13-8), if the resistance is
out of specification, or if any wire has continuity to
ground.
REGULATOR/RECTIFIER
WIRE HARNESS INSPECTION
Turn the ignition switch OFF.
Remove the body cover (page 3-6).
Disconnect the regulator/rectifier 3P (Black) connec-
tor, and check them for loose contact or corroded
terminals.
Check the regulator/rectifier 3P connector terminals
(wire harness side) as follows:
• Measure the voltage between the Red wire termi-
nal (+) of the 3P (Black) connector and ground (–).
There should be battery voltage at all time.
• Check for continuity between the Green wire ter-
minal of the 3P (Black) connector and ground.
There should be continuity at all time.
REMOVAL/INSTALLATION
Remove the body cover (page 3-6).
Disconnect the regulator/rectifier 3P connectors.
Remove the mount bolts and regulator/rectifier.
Installation is in the reverse order of removal.
STANDARD: 0.1 – 1.0
Ω
(at 20
°
C/68
°
F)
ALTERNATOR 3P CONNECTOR
REGULATOR/RECTIFIER
3P (BLACK) CONNECTOR
BOLTS
REGULATOR/RECTIFIER
3P CONNECTORS