Honda SH300I 2006, Manual

Page: 163 / 511

FUEL SYSTEM (PGM-FI)
6-53
Route the hoses
properly (page 1-
19).
Installation is in the reverse order of removal.
• Tighten the connecting hose band screw until the
clearance between the screw and band end is 7.0
±
1.0 mm (0.28
±
0.04 in)
THROTTLE BODY
REMOVAL
• If the sensor unit has been removed, perform the
TP sensor reset procedure (page 6-58).
Remove the luggage box (page 3-5).
Disconnect the sensor unit 5P (Black) connector and
IACV 4P connector.
Release the wire clamp boss from the throttle body.
Loosen the throttle cable lock nuts.
Release the throttle cable from the cable bracket.
Disconnect the throttle cables from the throttle
drum.
Loosen the connecting hose band screw and insula-
tor band screw.
Remove the throttle body.
• Seal the intake pipe with a shop towel or cover it
with a piece of tape to prevent any foreign mate-
rial from dropping into the engine.
TORQUE: Air cleaner housing mounting washer bolt
11 N·m (1.1 kgf·m, 8 lbf·ft)
7.0
±
1.0 mm
(0.28
±
0.04 in)
IACV 4P CONNECTOR
SENSOR UNIT 5P
(BLACK) CONNECTOR
WIRE CLAMP BOSS
Be careful not to
damage the threads
of throttle cable.
THROTTLE CABLES
LOCK NUTS
INSULATOR
BAND SCREW
THROTTLE BODY
CONNECTING HOSE
BAND SCREW