DRIVE PULLEY/DRIVEN PULLEY/CLUTCH
11-9
Install the snap ring to the groove of the crankcase
cover.
• Check that the snap ring is seated in the groove.
• Do not reuse the snap ring which could easily
spin in the groove.
Install the element of the belt case air cleaner (page
4-15).
LEFT DRIVE SHAFT BEARING REPLACEMENT
Remove the left drive shaft bearing from the left
crankcase cover using special tools.
Drive in the crankshaft bearing to the left crankcase
cover using special tools.
INSTALLATION
• Route the wires properly (page 1-21).
Check the rubber seal for deterioration or damage,
replace it if necessary.
Clean the rubber seal groove in the left crankcase
cover.
Install the rubber seal onto the left crankcase cover.
SNAP RING
TOOLS:
Bearing remover set, 20 mm
07936-3710600
Remover weight
07741-0010201
Bearing remover handle
07936-3710100
REMOVER WEIGHT
SHAFT HANDLE
REMOVER SHAFT
TOOLS:
Driver
07749-0010000
Attachment, 42 x 47 mm
07746-0010300
Pilot, 20 mm
07746-0040500
DRIVER
ATTACHMENT/PILOT
RUBBER SEAL
maxiscooter-club.ru
Summary of Contents for NSS250A Reflex 2001-2007
