Honda NC700 2012, Service Manual

Page: 293 / 773

8-14
dummyhead dummyhead
COOLING SYSTEM
Installation is in the reverse order of removal.
• Replace the O-rings, gaskets and sealing washer
with new ones.
• Apply engine oil to the large O-ring.
• Align the water pump slit with camshaft tab.
• Align the water bypass hose index mark with the
water pump tab.
• Tighten the water hose band screws to the specified
range as shown.
• Route the hoses properly (page 1-25).
Fill the recommended coolant mixture to the filler neck
and bleed the air (page 8-6).
DISASSEMBLY/ASSEMBLY
When engine removed, remove the water pump
assembly.
Remove the following:
– 6 x 32 mm bolts [1]
– Sealing washer [2]
– Water pump cover [3]
– Gasket [4]
– Plate [5]
– Gasket [6]
– Dowel pins [7]
– Water pump body [8]
Assembly is in the reverse order of disassembly.
• Do not disassemble the water pump body.
• Replace the gasket and sealing washer with new
ones
RADIATOR RESERVE TANK
REMOVAL/INSTALLATION
Remove the lower cowl (page 2-28).
Release the O
2
sensor wire [1] from the radiator reserve
tank [2].
Release the reserve tank overflow hose [3].
Remove the bolt [4] and radiator reserve tank.
0 – 1 mm
(0 – 0.04 in)
[1] [2]
[3]
[4]
[5]
[6]
[8] [7]
[2]
[4]
[1]
[3]
Align