Honda NC700 2012, Service Manual

Page: 275 / 773

7-20
dummyhead dummyhead
FUEL SYSTEM
7. Check if the MIL blinks.
8. Turn the ignition switch OFF.
9. Connect the ECT sensor 2P connector [1].
INJECTOR
REMOVAL
Relieve the fuel pressure and disconnect the quick
connect fitting from the injector side (page 7-4).
Remove the battery box (page 2-31).
Disconnect the injector 2P (Gray) connectors [1].
Remove the clip [2] from the fuel rail.
Remove the bolts [3], collars [4] and injector assembly
[5].
Remove the retainers [1] from the injector/fuel rail.
If the MIL begins short blink (0.3 seconds), the throttle valve fully closed position is reset.
If the MIL stays lit, the throttle valve fully closed position is not reset, repeat the reset procedure from step 1.
MIL ON
MIL OFF
0.1
seconds
1.2
seconds
within 10 seconds
RESET RECEIVING PATTERN SUCCESSFUL PATTERN
0.3 seconds
0.3 seconds
[1]
[4]
[3]
[1]
[5] [2] [4] [3]
[1]