Honda NC700 2012, Service Manual

Page: 235 / 773

5-4
dummyhead dummyhead
IGNITION SYSTEM
SERVICE INFORMATION
GENERAL
• The ECM/PCM may be damaged if dropped. Also if the connector is disconnected when current is flowing, the excessive
voltage may damage the module. Always turn off the ignition switch before servicing.
• Use spark plug of the correct heat range. Using a spark plug with an incorrect heat range can damage the engine.
• When servicing the ignition system, always follow the steps in the troubleshooting table (page 5-5).
• Some electrical components may be damaged if terminals or connectors are connected or disconnected while the ignition switch
is turned to ON position and current is present.
• A faulty ignition system is often related to poorly connected or corroded connections. Check those connections before
proceeding.
• Make sure the battery is adequately charged. Using the starter motor with a weak battery results in a slower engine cranking
speed as well as no spark at the spark plug.
• For ECM/PCM service (page 4-67).
• Refer to following components informations:
– Ignition switch (page 22-24)
– Engine stop switch (page 22-25)
– Bank angle sensor (page 4-65)
– Sidestand switch (page 22-28)
– Neutral switch (page 22-27)
• The following color codes are used throughout this section.
SPECIFICATIONS
TORQUE VALUE
Bl = Black Bu = Blue Lg = Light green R = Red Y = Yellow
Br = Brown G = Green O = Orange W = White
ITEM SPECIFICATIONS
Spark plug (Iridium) IFR6G-11K (NGK)
Spark plug gap 1.0 – 1.1 mm (0.039 – 0.043 in)
Ignition coil peak voltage 100 V minimum
CKP sensor peak voltage (at 20°C/68°F) 0.7 V minimum
Ignition timing ("F" mark) 12° BTDC at idle
ITEM Q'TY
THREAD TORQUE
REMARKS
DIA. (mm) N·m (kgf·m, lbf·ft)
Timing hole cap 1 14 10 (1.0, 7) Apply grease to the threads.
Right crankcase cover wire clamp
bolt (NC700XD/SD) 2 6 12 (1.2, 9) Apply locking agent to the threads.
Coating width; 6.5 ± 1.0 mm (0.26 ±
0.04 in) except 2.0 ± 1.0 mm (0.08 ±
0.04 in) from tip