12
Installation
Installation
We strongly recommend that an authorized Honda dealer installs your Robotic Lawn mower. Installation by an
authorized Honda dealer will ensure that your system is working correctly.
Do not use anything other than supplied items and docking station bundled.
Checking conditions for installation
Check with the dealer that performed the installation if the docking station and boundary wire are installed
according to the conditions below. Also periodically con
fi
rm that these conditions are still met.
If any of these conditions are not met, consult your dealer.
We recommend that the main power supply is professionally installed in accordance with local laws and regulations.
Conditions for installing the docking station
Image
Condition
5° (8.7%)
5° (8.7%)
5° (8.7%)
5° (8.7%)
• The docking station must be installed on a
fl
at
surface with an inclination of no more than 5° (8.7%).
• The docking station must not be curved.
• The screws must be
fi
rmly tightened.
• Before installing the docking station, check the ground
condition, which may vary seasonally.
• If installing the docking station directly on the
lawn, cut the grass on which the docking station
will be located as short as possible.
• If the docking station is installed incorrectly, the
lawn mower may not be able to charge.
Docking direction
CW (Clockwise)
CCW (Counter-clockwise)
Right side wire
connector
(Type 0)
Left side wire
connector
(Type 2)
Right side wire
connector
Left side wire
connector
Type 0
Type 2
You need to set the loop direction CW (Clockwise)
or CCW (Counter-clockwise) when the lawn mower
returns to the docking station.
You also need to connect the connectors of the
boundary wire with the terminals of the docking
station with reference to the left table.
NOTE:
- If your lawn mower is an HRM310, the max
length of the boundary wire is 1,310 ft
(400 m).
More than
3.3 ft (1m)
0-7.9 in
(0-20 cm)
More than
6.6 ft (2m)
More than
3.3 ft (1m)
3.3 ft
(1m)
6.6 ft
(2m)
Corner
Pattern A
Pattern B
• The boundary wire must be laid according to the
fi
gure on the left (Pattern A or Pattern B).
• There must be no obstacles as follows:
Pattern A: within 3.3 ft (1m) from the station
Pattern B: within 6.6 ft (2m) from the station
• There must not be foreign objects within the work
area near the docking station (in the shaded area
indicated in the image).
• The boundary wire under the docking station must
be laid toward the outside of the work area.
• The boundary wire must be installed into the
“outer” groove located on the bottom of the
docking station.
