17-22
d. SHIFT SHAFT B CORRECTION
Correct the shift shaft B with the seal holder removed.
Correct the shift shaft B only when the shift shaft B is raised or
when it is disengaged from the shift shaft A in the mounting
case.
Remove the following pars before correction.
– Gear case assembly (P. 14-3, 42)
1) Turn the shift shaft B clockwise until the shift shaft A comes
in contact with the stopper in the mounting case as shown.
If the shift shaft B comes in contact with the stopper before
the shift shaft A does, raise the shift shaft B and turn it
counterclockwise until it engages with the shift shaft A.
Then turn the shift shaft B clockwise until the shift shaft A
comes in contact with the stopper.
NOTICE
2) Raise the shift shaft B slowly while holding the shift shaft A
in contact with the stopper in the mounting case.
3) With the raised shift shaft B pushed against the stopper in
the mounting case, lower the shift shaft B slowly and
engage it with the shift shaft A.
Hold the shift shaft A not to move when engaging it with
the shift shaft B.
4) After correction, check for proper shifting of the gear.
5) Install the seal holder (P. 17-23) and the gear case assembly
NOTICE
[4]
SHIFT SHAFT B
(If the shift shaft B comes in contact with the
stopper before the shift shaft A does, raise the
shift shaft B and turn it counterclockwise.)
[3]
SHIFT
SHAFT A
[3]
SHIFT
SHAFT A
[3]
SHIFT
SHAFT A
[1] STOPPER
[2]
SHIFT SHAFT B
(Raise the shift shaft B
and turn it clockwise.)
[4]
SHIFT SHAFT B
(Lower slowly and engage
with the shift shaft A)
[1]
STOPPER
[3]
SHIFT
SHAFT A
[1]
STOPPER
[2]
SHIFT SHAFT B
(Turn clockwise.)
