14-93
10) Install the lower mount collar and the lower rubber mount
on the extension case.
• Install the lower mount collar with the smaller diameter
side toward the lower rubber mount.
• Install the lower rubber mount with the “OUT” mark
toward out.
11) Install the 12 x 225 mm hex. bolt, two 12 mm washers and
the 12 mm self-locking nut. Holding the 12 mm self-locking
nut with a wrench, tighten the 12 x 225 mm hex. bolt to the
specified torque.
TORQUE: 83 N.m (8.5 kgf.m, 61 lbf.ft)
NOTICE
12) Connect the ground cable with the 6 x 12 mm flange bolt.
13) Install the lower mount housing on the extension case, and
tighten the three 8 mm washers and the three 8 x 30 mm
hex. bolts.
14) Remove the hoist hooks from the engine hangers and
lower the outboard motor to the lowermost position.
15) Install the following pars.
– Gear case assembly (P. 14-5 and 44)
– L./R. engine under cover (P. 4-14)
– Engine cover (P. 4-2)
[4]
8 x 30 mm
HEX. BOLT (3)
[1]
12 x 225 mm HEX. BOLT
[2]
12 mm SELF-
LOCKING NUT
[4]
LOWER RUBBER
MOUNT
[5]
“OUT” MARK
[6]
LOWER MOUNT
COLLAR
[3]
12 mm
WASHER (2)
[1]
LOWR MOUNT
HOUSING
6 x 12
[2]
GROUND CABLE
[3]
8 mm WASHER (3)
