10-5
3. CAMSHAFT/ROCKER ARM
DISASSEMBLY
Remove the following parts.
– Engine cover (P. 4-2)
– L./R. engine under covers (P. 4-9)
– Ignition coil/spark plug (P. 3-6)
– Cylinder head cover (P. 10- 2)
1) Move the remote control lever to the “N” (Neutral)
position.
2) Turn the crankshaft pulley clockwise until it sets the No.1
piston at the top dead center of its compression stroke (P.
3-12).
Remove the following parts.
– Crankshaft pulley/cam chain (P. 9-2)
3) Disconnect the CMP sensor 3P connector. Remove the
harness band clip from the clip bracket F.
4) Remove the 6 x 16 mm flange bolts from the No.5 rocker
shaft holder, then remove the CMP sensor and the CMP
hole plug.
5) Remove the 15.2 x 1.9 mm O-rings from the CMP sensor
and the CMP hole plug.
Replace the O-rings with the new ones on assembly.
6) Secure the hex. part of the intake camshaft with a wrench
or equivalent tool.
6 x 16 (2)
[2]
CMP SENSOR
[1]
CMP HOLE PLUG
[1]
INTAKE CAMSHAFT
[3]
CMP SENSOR 3P
CONNECTOR
[2]
HARNESS
BAND CLIP
[1]
CLIP
BRACKET F
