6
| English
During operation
Always hold the garden tool firmly in your hand.
Walk slowly forwards as you work, observe the nozzle
outlet at all times.
To reduce the risk of injury, operate the unit only with a
properly mounted blower tube.
The flat nozzle produces a broad and powerful airstream
at ground level. It can be aimed and controlled very
accurately.
This garden tool is design to be used by one person only.
Do not allow other persons in the work area.
Do not direct the airflow towards bystanders or animals
since the airflow can blow small objects at great speeds.
This product is fitted with thermal protection for
safety – if the product overheats the power output will
be automatically reduced to prevent damage to the tool.
If the overheating still occurs, the product will switch
off and will not start again until a safe temperature is
reached. Refer to the battery and battery carrier manual
for troubleshooting.
To reduce the risk of accidents, take a break in good time
to avoid tiredness or exhaustion.
If there is a noticeable change in running behaviour
(e. g. higher vibration), stop work and rectify the cause of
the problem – refer to troubleshooting
After operation
Always make sure the product is turned off and remove
the battery adapter from the garden tool.
Troubleshooting
Problem
Possible Cause
Corrective Action
Machine does not start
after turning off
The switch was not turned off
properly before the battery adapter
was inserted
Turn the switch off, remove the battery adapter from
the product for 5 seconds. Re-insert the battery
adapter into the product.
Machine runs
intermittently
On/Off switch defective
Have the power tool repaired by an authorised
service dealer.
Low battery capacity
Ensure battery is fully charged before use.
The machine is overheated
Allow tool to cool and try again.
Battery discharged
Recharge battery.
Battery too hot/cold
Allow to cool/warm.
Machine defective
Contact authorised service dealer.
Machine fails to operate
Battery carrier defective
Contact authorised service dealer. See battery
carrier manual.
Battery adapter not fully inserted
Ensure battery adapter is inserted correctly.
Garden tool is too hot
Allow tool to cool and try again.
Trigger engaged when battery fitted Release trigger and reapply.
Tube obstructed
Switch off the machine, remove battery and remove
material.
Battery adapter contacts on
machine damaged/ obstructed
Clean contacts/Contact authorised service dealer.
Machine does not blow
Tube obstructed
Remove battery adapter Clear tube.
Inlet guard obstructed
Remove battery adapter Clear inlet guard.
Excessive vibrations/
noise
Machine defective
Contact authorised service dealer.
Run time per battery
charge too low
Battery dead or defective
Replace the battery.
Tube cannot be mounted
on the machine
Incorrect assembly
See “assembly”.
Blower tube is damaged/defective
Replace the tube.
If you are unable to resolve the problem using the troubleshooting guide then please contact your dealer in the first
instance.
