3-3
dummyhead
dummyhead
MAINTENANCE
ENGINE OIL LEVEL CHECK/CHANGE
CHECK
Place the engine on a level surface.
Remove the oil filler cap [1] and check the oil level in
the oil filler neck [2].
If the oil level is low, fill with recommended oil to the
upper level of the oil filler neck.
Check that the oil filler cap packing [3] is in good
condition; replace it if necessary.
Install and tighten the oil filler cap securely.
CHANGE
Place the engine on a level surface, and place a
suitable container under the drain plug bolt [1].
Remove the oil filler cap [2], drain plug bolt, and drain
plug washer [3], and drain the engine oil into a suitable
container.
Please dispose of used oil in a manner that is
compatible with the environment. We suggest you take
used oil in a sealed container to your local recycling
center or service station for reclamation. Do not throw it
in the trash, pour it on the ground, or pour it down a
drain.
Install the drain plug bolt with a new drain plug washer
and tighten it to the specified torque.
Add the specified amount of recommended oil into the
engine.
After adding the engine oil, check the oil level.
Check that the oil filler cap packing [4] is in good
condition; replace it if necessary.
Install and tighten the oil filler cap securely.
Make sure there are no oil leaks.
[1]
[3]
[2]
Used oil contains substances that have been
identified as carcinogenic. If repeatedly left in
contact with the skin for prolonged periods, it may
cause skin cancer. Wash your hands thoroughly
with soap and water as soon as possible after
contact with used oil.
TORQUE: 18 N·m (1.8 kgf·m, 13 lbf·ft)
SAE 10W - 30 is
recommended for
general use. Other
viscosities shown in
the chart may be
used when the
average
temperature in your
area is within the
recommended
range.
RECOMMENDED OIL:
SAE 10W-30
API service classification: SE or higher
OIL CAPACITY: 0.28 Liter (0.30 US qt, 0.25 Imp qt)
SAE VISCOSITY GRADES
AMBIENT TEMPERATURE
[2]
[1]
[4]
[3]
