Honda GP160H, Manual, Page: 82 / 114

10-3
dummyhead dummyhead
OTHER ELECTRICAL
OIL ALERT UNIT
REMOVAL/INSTALLATION
Disconnect the oil alert unit connectors [1].
Remove the bolt (6 x 12 mm) [2] and oil alert unit [3].
Install the oil alert unit and bolt.
Hold the oil alert unit against the boss [4] of the stay,
and then tighten the bolt.
• Route the wire harness properly (page 2-8).
OIL LEVEL SWITCH INSPECTION
Check the oil level (page 3-3).
Disconnect the oil alert unit connector [1].
Check the continuity between the switch terminal and
engine ground.
There should be no continuity when the engine is full of
oil.
Drain the engine oil completely (page 3-3).
Check the continuity between the switch terminal and
engine ground.
There should be continuity.
Check the continuity between the switch terminals while
filling the engine with oil.
The ohmmeter reading should go from continuity to no
continuity as the oil is filled.
If the correct continuity is not obtained, replace the oil
level switch (page 10-2).
ENGINE STOP SWITCH INSPECTION
Remove the engine stop switch connector [1].
Check the continuity between the terminal and engine
ground at each switch position.
If the correct continuity is not obtained, replace the
engine stop switch (page 10-2).
• Route the wire harness properly (page 2-8).
[1]
[3] [2] [4]
[1]
Switch position Continuity
ON No
OFF Yes
[1]