Honda GP160H, Manual

Page: 53 / 114

6-6
dummyhead dummyhead
FUEL SYSTEM
CARBURETOR
DISASSEMBLY/ASSEMBLY
Remove the carburetor (page 6-5).
Before disassembly, clean the outside of the carburetor.
Gasoline is highly flammable and explosive. You
can be burned or seriously injured when handling
fuel.
• Keep heat, sparks, and flame away.
• Handle fuel only outdoors.
• Wipe up spills immediately.
To prevent serious eye injury, always wear safety
goggles or other eye protection when using
compressed air.
ASSEMBLY:
Before installing, clean
thoroughly with low-
pressure compressed air.
PILOT JET SET
MAIN NOZZLE
MAIN JET
ASSEMBLY:
Before installing, clean
thoroughly with low-pressure
compressed air.
Lightly lubricate the O-ring [1]
to ensure easy installation
into the carburetor body.
ASSEMBLY:
Before installing, clean
thoroughly with low-
pressure compressed
air.
FLOAT CHAMBER
ASSEMBLY:
Install the float chamber to the
carburetor body at an angle as shown.
UPPER
SIDE
UPPER
SIDE
NOTE 2:
NOTE 1:
LIMITER CAP
O-RING
FLOAT
FLOAT PIN O-RING
SET BOLT
SET BOLT GASKET
SCREW
(3 x 6 mm) (2)
CHOKE LEVER
LEVER SETTING PLATE
VALVE LEVER
SPRING
FUEL VALVE LEVER
FUEL VALVE
PACKING
SPRING PIN
CHECK:
Replace if necessary.
CARBURETOR BODY
FLOAT VALVE
FLOAT VALVE SPRING
DRAIN SCREW GASKET
DRAIN SCREW
[1]
0 – 30°
PILOT SCREW
THROTTLE STOP SCREW
NOTE 1 IDLE SPEED ADJUSTMENT page 3-6
NOTE 2 PILOT SCREW REPLACEMENT/INSTALLATION page 6-8