Honda GOLDWING GL1800/A 2015, Owner'S Manual, Page: 181 / 289

178
Servicing Your Honda
Engine Oil & Filter
Checking & Adding Oil
Refer to
Safety Precautions
on page 154 .
RIGHT SIDE
upper level mark
oil fill cap/dipstick
lower level mark
1. Park your motorcycle on its center stand on a firm, level surface.
2. Remove the right engine side cover ( page 168 ).
3. Start the engine and let it idle for 3 – 5 minutes. Make sure the low oil
pressure indicator goes off. If the indicator remains on, stop the engine
immediately.
4. Stop the engine and wait 2 – 3 minutes.
5. Remove the oil fill cap/dipstick and wipe it clean.
6. Insert the oil fill cap/dipstick until it seats, but don’t screw it in.
7. Remove the oil fill cap/dipstick and check the oil level.
• If the oil is at or near the upper level mark — you do not have to add oil.
• If the oil is below or near the lower level mark — add the recommended oil
until it reaches the upper level mark. (Do not overfill.)
8. Reinstall the oil fill cap/dipstick.
9. Reinstall the right engine side cover.
10. Check for oil leaks.