Honda CBR125R, Owner'S Manual

Page: 239 / 430

CLUTCH/GEARSHIFT LINKAGE
10-15
Attach the clutch center holder to the pressure plate
using the clutch spring bolts to hold the clutch cen-
ter, then tighten the clutch center lock nut to the
specified torque using the special tools.
Install the clutch springs, lifter plate and bolts.
Tighten the lifter plate bolts to the specified torque
in a crisscross pattern in 2 or 3 steps.
Install the clutch lifter bearing.
Install the right crankcase cover (page 10-8).
GEARSHIFT LINKAGE
REMOVAL
Remove the following:
– Right crankcase cover (page 10-5)
– Clutch assembly (page 10-9)
– Gearshift arm (page 10-18)
Clean the gearshift spindle end.
Remove the shift drum stopper arm bolt and shift
drum stopper arm while holding the shift drum
stopper arm using a screwdriver.
Pull down the spindle arm, then pull out the gear-
shift spindle assembly from the crankcase.
TOOLS:
Clutch center holder
07GMB-KT70101
Lock nut wrench, 20 x 24 mm 07716-0020100
Extension bar/handle 07716-0020500
TORQUE: 74 N·m (7.5 kgf·m, 55 lbf·ft)
CLUTCH CENTER HOLDER
LOCK NUT WRENCH
LOCK NUT
TORQUE: 12 N·m (1.2 kgf·m, 9 lbf·ft)
BOLTS/SPRINGS
BEARING
LIFTER PLATE
STOPPER ARM BOLT
SPINDLE ARM
GEARSHIFT SPINDLE ASSEMBLY