Overheating (Segment H flashes in coolant temperature gauge)
The engine is overheating when the following
occurs:
●
The segment H flashes in the coolant
temperature gauge.
●
Acceleration becomes sluggish.
If this occurs, pull safely to the side of the
road and perform the following
procedure.
Extended fast idling may cause the segment
H to flash.
NOTICE
Continuing to ride with an overheated engine
can cause serious damage to the engine.
1.
Stop the engine using the ignition switch,
and then turn the ignition switch to the
(On) position.
2.
Check that the radiator fan is operating,
and then turn the ignition switch to the
(Off) position.
If the fan is not operating:
Suspect a fault. Do not start the engine.
Transport your motorcycle to your dealer.
If the fan is operating:
Allow the engine to cool with the ignition
switch in the (Off) position.
3.
After the engine has cooled, inspect the
radiator hose and check if there is a leak.
If there is a leak:
Do not start the engine. Transport your
motorcycle to your dealer.
4.
Check the coolant level in the reserve
tank.
u
Add coolant as necessary.
5.
If 1-4 check normal, you may continue
riding, but closely monitor the
temperature gauge.
20180116165849_32K0AC000_eng_BOOK Page 104 Tuesday, January 16 2018 17:05:27 JST
Troubleshooting
101
